When ready to light the torch, after attaching the right tip or head as
directed in accordance with the thickness of metal to be handled, it will
be necessary to regulate the pressure of gases to secure the neutral flame.
The oxygen will have a pressure of from 2 to 20 pounds, according to the
nozzle used. The acetylene will have much less. Even with the compressed
gas, the pressure should never exceed 10 pounds for the largest work, and
it will usually be from 4 to 6. In low pressure systems, the acetylene will
be received at generator pressure. It should first be seen that the
hand-screws on the regulators are turned way out so that the springs are
free from any tension. It will do no harm if these screws are turned back
until they come out of the threads. This must be done with both oxygen and
acetylene regulators.
Next, open the valve from the generator, or on the acetylene tank, and
carefully note whether there is any odor of escaping gas. Any leakage of
this gas must be stopped before going on with the work.
The hand wheel controlling the oxygen cylinder valve should now be turned
very slowly to the left as far as it will go, which opens the valve, and
it should be borne in mind the pressure that is being released. Turn in the
hand screw on the oxygen regulator until the small pressure gauge shows a
reading according to the requirements of the nozzle being used. This oxygen
regulator adjustment should be made with the cock on the torch open, and
after the regulator is thus adjusted the torch cock may be closed.
Pages:
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122