One trouble met with in the adoption of this
process has been that the operation looks so simple and so easy of
performance that unskilled and unprepared persons have been tempted to try
welding, with results that often caused condemnation of the process, when
the real fault lay entirely with the operator.
The form of torch usually employed is from twelve to twenty-four inches
long and is composed of a handle at one end with tubes leading from this
handle to the "welding head" or torch proper. At or near one end of the
handle are adjustable cocks or valves for allowing the gases to flow into
the torch or to prevent them from doing so. These cocks are often used for
regulating the pressure and amount of gas flowing to the welding head, but
are not always constructed for this purpose and should not be so used when
it is possible to secure pressure adjustment at the regulators (Figure 16).
Figure 16 shows three different sizes of torches. The number 5 torch is
designed especially for jewelers' work and thin sheet steel welding. It is
eleven inches in length and weighs nineteen ounces. The tips for the number
10 torch are interchangeable with the number 5. The number 10 torch is
adapted for general use on light and medium heavy work. It has six tips and
its length is sixteen inches, with a weight of twenty-three ounces.
The number 15 torch is designed for heavy work, being twenty-five inches in
length, permitting the operator to stand away from the heat of the metal
being worked.
Pages:
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96